Influence Of Magnetron Sputtering Process Parameters: Deposition Temperature
Sep 05, 2024| Influence of magnetron sputtering process parameters: deposition temperature
The deposition temperature also affects the mechanical properties of (Cr,Ti,Al) N quaternary coatings. Lin Jing et al. adopted pulsed DC magnetron sputtering and arc ion plating composite deposition techniques to prepare (Cr, Ti, Al) N quaternary coatings at 300 ℃ and 400 ℃ respectively [62]. The experimental results show that the (Cr,Ti,Al) N coatings prepared at 400 ℃ exhibit better mechanical properties and wear resistance than those prepared at 300 ℃. With the increase of deposition temperature, the atomic diffusion ability is enhanced, the coating is denser, and the nitride reaction is more adequate, so the hardness of (Cr,Ti,Al) N coating is greatly increased. The experimental results also show that with the increase of deposition temperature, the friction coefficient and wear rate of the coating are reduced, and the cutting life of the coating tool is increased. This is because the hardness of the coating increases with the increase of deposition temperature. According to Archard's theory, the friction factor of the coating is inversely proportional to the hardness, so the friction factor of the coating is reduced. In addition, when the deposition temperature is high, the coating has stronger resistance to elastic deformation and plastic deformation, and better resistance to damage, so it is not easy to crack during the friction process, which is conducive to reducing the wear rate of the coating. The coating prepared at 400 ℃ has higher hardness and toughness, and lower friction factor, which is conducive to extending the cutting life of the tool.
IKS PVD company, decorative coating machine, tools coating machine, DLC coating machine, optical coating machine, PVD vacuum coating line, the turn-key project is available. Contact us now, E-mail: iks.pvd@foxmail.com


