Bias Power Supply
Aug 05, 2024| Bias power supply
The bias power supply is used in both multi-arc ion and magnetron sputtering coating technology. Only because the ionization rate of magnetron sputtering is much lower than that of multi-arc ion plating, the power of the required bias power supply is smaller. At present, many devices are equipped with both magnetron sputtering targets and multi-arc targets, and the selection of bias power supply power should be determined by the requirements of multi-unit operation. The early bias voltage was mainly DC bias power supply with thyristor technology, and now it is mostly unipolar, DC superimposed pulse and bipolar pulse bias power supply manufactured by high-frequency inverter technology. The biasing power supply is mainly used for glow cleaning in the process of multi-arc ion and magnetron sputtering coating, ion bombardment and film deposition to apply biasing pressure on the plated workpiece and produce glow during glow cleaning. In the ion bombardment used to accelerate ions, improve the energy of ion bombardment into the surface of the workpiece, to achieve the purpose of sputtering cleaning effect and improve the film binding force, in film deposition, it is also used to increase the ion energy, promote and improve the film growth, will also improve the film binding force, the following are several common waveform of the bias power supply: unipolar pulse bias power supply main features 1. High frequency unipolar pulse bias pressure on the workpiece, compared with DC bias, because of the voltage interrupt gap, can effectively reduce the number of ignition, protect the surface of the workpiece. 2. During the pulse gap, the accumulated charge on the surface of the workpiece can be neutralized, thereby reducing the ignition caused by the accumulation of surface charge. 3. The fast turn-off ability of high-frequency inverter technology can effectively reduce the energy released by each spark, even when the spark appears, it can significantly reduce the degree of large damage to the workpiece surface. 4. The ion energy deposited to the workpiece surface during the pulse gap is very low. 5. The film forming speed and quality can be improved and controlled by adjusting the frequency and duty cycle. Main features of DC superimposed pulse bias power supply 1. It has all the characteristics of unipolar pulse bias power supply. 2. In DC and DC superimposed pulse mode, the problem of low ion energy between unipolar pulse gaps is eliminated. The function of the negative pulse is the same as that of the unipolar pulse bias power supply, and the function of the positive pulse is mainly to attract electrons in the plasma to neutralize the positive charge accumulation on the surface of the workpiece. Because the mass of the electron is much smaller than that of the ion, acceleration is easy, so the amplitude of the positive pulse is much smaller than that of the negative pulse, usually 10 ~ 100V, and the current integral of the positive and negative pulses should be equal. So the power of the positive power supply is much less than the power of the negative power supply. 2. When the positive supply voltage is zero, the bipolar pulse bias becomes unipolar pulse bias.
IKS PVD company, decorative coating machine, tools coating machine, DLC coating machine, optical coating machine, PVD vacuum coating line, the turn-key project is available. Contact us now, E-mail: iks.pvd@foxmail.com


