Brinell Hardness

May 11, 2021|

Brinell Hardness

The quenched steel ball or hard alloy ball with diameter D is used as the indentation head, and the corresponding test force F is pressed into the surface of the specimen. After the specified holding time, the test force is removed and an indentation with diameter D is obtained. Divide the test force by the surface area of the indentation, and the obtained value is the Brinell hardness value, which is expressed as HBS or HBW.
The difference between HBS and HBW is the head. HBS refers to the indentation head as a hardened steel ball, which is used for the determination of materials with a Brinell hardness value below 450, such as mild steel, gray cast iron and non-ferrous metals. HBW denotes the indentation head as hard alloy, used for the determination of Brinell hardness value below 650 materials.
For the same test block, when other test conditions are exactly the same, the two test results are different, HBW value is often greater than HBS value, and there is no quantitative rule to follow._20210426141528
Since 2003, China has been equivalent to the international standards, the steel ball head has been canceled, all the use of carbide ball head. Therefore, HBS ceased to be used, and HBW was used to represent the Brinell hardness symbol. A lot of times Brinell hardness is just Hb, which means HBW. However, HBS is still sometimes seen in literature papers.
Brinell hardness measurement method is suitable for cast iron, non-ferroalloy, all kinds of annealed and tempered steel, should not be too hard, too small, too thin and the surface is not allowed to have large indentation sample or workpiece.

IKS PVD company, decorative coating machine, tools coating machine, optical coating machine, PVD vacuum coating line, the turn-key project is available. Contact us now, E-mail: iks.pvd@foxmail.com


Send Inquiry