Vacuum pump
Jul 11, 2022| Vacuum pump
1 Structure and principle Vacuum refers to the pressure is less than 101.3kpa of the gaseous space where the gas can be extracted from the container, so that the gas pressure reduction device, can be called vacuum pump test room commonly used vacuum pump is oil seal mechanical vacuum pump, vacuum degree is generally 101~1Pa This kind of pump has a steel cylindrical stator, stator has an eccentric steel solid cylinder as the rotor, rotor diameter embedded with a spring slide, when the motor drives the rotor rotation, slide in the cylindrical cavity operation, so that the pump cavity is separated into two areas, the volume of periodic expansion and contraction After the gas container to be pumped in the pump inlet, when the pump cavity space increases, the suction to be pumped gas, with the rotor rotation, the gas is compressed after discharge from the exhaust port rotor rotation, suction compression exhaust process is repeated, the gas in the container is constantly reduced, the pressure is constantly reduced The whole machine is immersed in the lubricating oil box, the vapor pressure of lubricating oil is very low, it plays a lubrication seal and cold action with 2 use and precautions 1) Vacuum pump is mainly used for the following aspects in the inspection room: A dry vacuum pump and vacuum drying oven connection, sample in the vacuum drying oven at lower temperature to remove moisture from the sample and the high boiling point material difficult to volatilize In order to avoid the sample decomposition at high temperature vacuum distillation B decompression evaporate lutetium gold, can reduce the boiling point of material, make its distillation under the low temperature Is suitable for the decomposition of organic matter at high temperature distillation C vacuum filtration, for the special material difficult to filter, vacuum filtration can speed up the filtration speed and other can also be used for the need to vacuum test 2) precautions: A before opening the vacuum pump to check whether the liquid level of the oil in the pump is too much oil in the marking line of the oil hole, in operation with the gas from the vent outward splash; Oil is insufficient, cannot completely submerged pump body, short of sealing and lubrication, the vacuum pump body have damage B vacuum pump driven by motor, when using, should make the power supply voltage is consistent with the requirements of the motor voltage For three-phase motor, remove the belt before sending, check motor rotation direction is consistent, not reverse the motor, pump oil jet After the inspection, connect the belt again C vacuum pump can not directly pump coagulable vapor D vacuum pump operation should pay attention to the temperature of the motor, not exceed the specified temperature, there should be no friction and metal banging sound if there is abnormal, should stop the machine for professional maintenance E Before stopping the pump, the inlet of the pump should be first through the atmosphere and then cut off the power supply, so as to prevent the pump oil back pressure into the pumping system. Therefore, it is best to connect a three-way piston at the inlet, so that the three-way piston is in both keep the system in a vacuum before stopping the pump body through the atmosphere Vacuum pump should be cleaned regularly at the inlet of the yarn net, so as not to fall into the pump solid small particles, damage the pump body tip: vacuum pump after six months or a year, must change the oil.

IKS PVD company, decorative coating machine, tools coating machine, DLC coating machine, optical coating machine, PVD vacuum coating line, the turn-key project is available. Contact us now, E-mail: iks.pvd@foxmail.com


